Santa Fe AWD V6-3.3L (2009)
Clutch Pedal Assembly: Testing and Inspection
Removal
NOTE:
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.
1. Remove the brake fluid from the clutch master cylinder reservoir with a syringe.
2. Clamp the clutch master cylinder hose(A). If there is no enough room for clamping, you can also clamp the hose from the brake master cylinder
side.
3. Disconnect the tube(A) from the cylinder by releasing the clutch master cylinder clamp.
4. Remove the ignition lock switch.
5. Remove the clutch pedal assembly mounting nuts (A-3ea) and bolt (B-2ea).
6. Remove the clutch pedal and the master cylinder assembly together.
Installation
NOTE:
-
The clutch pedal and the clutch master cylinder are supplied as an assembly.
-
Inspect the continuity of the ignition lock switch.
-
Remove the floor mat before adjusting the clutch pedal.