Santa Fe FWD L4-2.4L (2010)
11. This picture shows a TPMS sensor with a bad fit. Note that the valve bulb is not resting on the rim. This will not provide a good rim seal at the
valve hole.
12. This picture shows a TPMS sensor with a correct fit. Note that the valve bulb is resting against the rim.
13. Apply tire soap or lubrication to the top and bottom tire beads.
14. To fit the bottom bead, position the sensor at the 5 o'clock position relative to the head on the tire changing machine.
15. Place the tire on the rim so the bottom bead touches the edge of the rim after the sensor (@6 o'clock). Rotate the rim clockwise, and push down on
the tire at the 3 o'clock position to fit bottom bead
