Santa Fe FWD L4-2.4L (2010)
Rear Door Window Regulator: Service and Repair
Replacement
Rear Door Module Assembly Replacement
1. Remove the following parts.
A. Rear door trim.
B. Window glass.
C. Outside handle.
2. Loosen the outside handle base mounting screw (A).
3. Loosen the module (A) mounting bolts and latch mounting screws.
4. Disconnect the door module wiring harness (A), then remove the module assembly (B).
5. Installation is the reverse of removal.
NOTE:
-
Make sure the connector are plugged in properly and each rod is connected securely.
-
Make sure the door locks and opens properly.
