Santa Fe FWD V6-2.7L (2007)
After the adaptive values have been reset (erased), an "adaptive learning" procedure must be completed as shown.
3.
Attach a Hi-Scan Pro or GDS and select "Engine" menu, "Current Data" menu and throttle position sensor in volts ("THROTTLE POS. SENSOR"
"ACCEL. POS. S". or "ACCEL PEDAL 1 VOLT", depending on model).
4.
Drive the vehicle until the ATF temperature is within the temperature range shown.
5.
Request an assistant to monitor the Hi- Scan while accelerating the vehicle at small throttle openings (approximately 25-30% throttle). Hold the
accelerator pedal steady at a throttle position sensor value of 1.45-1.75v during several 1-2-3-4 upshifts. Repeat until normal gear transitions
occur.
6.
Repeat this procedure for 4-3, 3-2 and 2-1 downshifts.
NOTE:
Adaptive learning does not occur below the ATF temperature range previously shown.
WARRANTY INFORMATION:
Applicable warranty coverage applies
