Santa Fe FWD V6-2.7L (2007)
Replace the side airbag module, the curtain airbag module, SRSCM, SIS when deploying the side airbag. Replace the airbag when the airbag
wiring get damaged.
After a collision in which the airbags or the side air bags did not deploy, inspect for any damage or any deformation on the SRS unit and the side
impact sensors. If there is any damage, replace the SRS unit, the front impact sensor and/or the side impact sensors.
-
Do not disassemble the SRS unit, the front impact sensor or the side impact sensors.
-
Turn the ignition switch OFF, disconnect the battery negative cable and wait at least three minutes before beginning installation or replacement
of the SRS unit.
-
Be sure the SRS unit, the front impact sensor and side impact sensors are installed securely with the mounting bolts.
-
Do not spill water or oil on the SRS unit, or the front impact sensor or the side impact sensors and keep them away from dust.
-
Store the SRS unit, the front impact sensor and the side impact sensors in a cool (15 - 25 °C/ 59 - 77 °F) and dry (30 - 80% relative humidity,
no moisture) area.
WIRING PRECAUTIONS
SRS wiring can be identified by special yellow outer covering (except the SRS circuits under the front seats and the SRS circuits in the FEM of engine
room).
Observe the instructions described in this section.
-
Never attempt to modify, splice, or repair SRS wiring. If there is an open or damage in SRS wiring, replace the harness.
-
Be sure to install the harness wires so that they are not pinched, or interfere with other parts.
-
Make sure all SRS ground locations are clean, and grounds are securely fastened for optimum metal-to- metal contact. Poor grounding can cause
intermittent problems that are difficult to diagnose.
PRECAUTIONS FOR ELECTRICAL INSPECTIONS
