Santa Fe FWD V6-3.3L (2009)
Daytime Running Lamp Control Unit: Testing and Inspection
Inspection
1. The daytime running unit (A) is integrated in the BCM.
2. Check that the light operate according to the following timing chart.
3. If the daytime running light is not operated well, Inspect the connector and terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
If the terminals look OK, go to step 4.
4. Make these input tests at the connector by using ETM.
If any test indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, the BCM (Body control module) must be faulty; replace it.
