Santa Fe FWD V6-3.3L (2009)
Turn Signal Switch Lever.
11. Use a Feeler Gauge to verify the 2.5 mm +/- 0.5mm clearance.
12. Remove any burrs from the rear edge of the square opening and remove filings by blowing air in the outward direction, away from the bearings at the
column upper shaft.
13. Reinstall all removed parts and connect all connectors in the reverse order of removal.
14. Reconnect the battery cable and verify the turn signal switch and all components that have been removed or disconnected function correctly.
15. Reprogram the radio stations and reset the clock.