Santa Fe FWD V6-3.3L (2009)
Adjust the toe-in by turning the cambolt of the rear assist arm.
Left cambolt : Clockwise -> toe- out
Right cambolt : Clockwise -> toe- in
The variation of toe by a rotation of the cambolt :
About 4.3 mm (0.17 in)
CAUTION:
-
Each toe should be within 0.1° ± 0.1° (0.039± 0.039 in). If the difference between right and left is not within +0.2° (0.079 in), repeat adjustment.
-
After adjusting the cambolt, tighten the nut to the specified torque.
Tightening torque :
137.3 - 156.9N.m (14 - 16kgf.m, 101.3 - 115.7lb-ft)
Camber
Camber is the inward or outward tilting of the wheels at the top.
Camber [Front]
Standard value :
Camber angle (A) : -0.5°±0.5°
When the wheel tilts out at the top, then the camber is positive (+).
When the wheel tilts in at the top, then the camber is negative(-).
NOTE:
Camber is pre-set at the factory and doesn't need to be adjusted. If the camber is not within the standard value, replace the bent or damaged parts.
Camber [Rear]
Standard value :
Camber angle (A) : -1°±0.5°
Difference between right and left angle is within 0.5°
Adjust the camber by turning the cambolt of the rear lower arm.