Santa Fe FWD V6-3.3L (2009)
DO NOT reuse the valve core if it has been removed. If the valve core has been removed, install only a NON BRASS type valve core as a
replacement.
Cautions during TPMS sensor removal and installation:
1.
Removal:
^
Start unseating the tire bead about 6 inches (15cm) from the TPMS valve stem.
^
Make sure that the tool does not touch the TPMS sensor while unseating the tire bead.
^
When unfastening the TPMS sensor, hold it securely without rocking.
2.
Installation:
^
Do not exceed the allowed torque and DO NOT use electric or pneumatic tools. Tightening torque = 3.0 lb. ft. (4 Nm, 0.4 Kg. m)
^
Attach the sensor to the rim firmly.
^
Hold the sensor and assemble the valve stem to the sensor by hand.
^
Secure the TPMS sensor by rotating the valve stem clockwise with a torque wrench.
^
After installing the TPMS sensor, check if it is attached to the rim firmly.