Santa Fe FWD V6-3.3L (2009)
5. Select Current Data and "Throttle Position".
6. Drive the vehicle until the ATF temperature is within the range shown.
7. Request an assistant to monitor the GDS. Accelerate from a stop at the specified TPS specification while the transmission shifts through gears
1-2-3-4-5-6 and decelerate slowly to a stop. Stop for 5 seconds. Repeat 5 times.
NOTE:
Hold the accelerator pedal steady during the upshifts.
CAUTION:
Do not exceed legal speed limits.
If additional adaptation is needed, perform the following additional procedures:
8. Perform several sequential downshifts (5-4, 4-3, 3-2 and 2-1) at small to moderate throttle openings.
9. Perform several skip shifts (6-4, 5-3, 5-2, 3-1, etc.) at moderate to large throttle openings.
10. With the vehicle stopped, move the shift lever from P to N to D and back, stopping 3~5 seconds in each gear. Repeat 5 times.