Santa Fe GLS V6-2.7L (2002)
20.
With a # 2 phillips offset screwdriver install the 2 self tapping screws in the front wheel well through the holes in the cover and into the retainers
from which they were removed.
21.
While holding the rear-top portion of the cover tight to the vehicle, insert the # 8 self-drilling screw where indicated on the cover. Insert the screw
using the phillips drill bit and variable speed drill.
22.
Remove trim removal tool after installation is complete and confirm that there is sufficient clearance between the rear door and the running board
cover.
PARTS INFORMATION
WARRANTY INFORMATION