Santa Fe GLS V6-2.7L (2002)
Upper Side Moulding / Trim: Service and Repair
BODY SIDE MOLDINGS
REMOVAL AND INSTALLATION
ROOF SIDE GARNISH
1. Remove the roof side garnish using a flat bladed screwdriver.
CAUTION: When prying with a flat bladed screwdriver, wrap it with protective tape to prevent damage.
In order not to scratch the body and roof side garnish, use protective tape on the body.
2. Pull the roof side garnish up, then remove it.
3. Installation is the reverse of the removal process.
NOTE: If necessary, replace any damaged clips.