Santa Fe GLS V6-2.7L (2002)
1. Install.
2. Perform a road test.
NOTE: If there is a small quantity of air in the brake line, it can affect the brake pedal stroke so you must bleed the system carefully.
CAUTION: When replacing the piston seal, check the pedal stroke. If the pedal stroke is too great, the piston may not retain the piston seal.
Adjust as follows :
1. After removing the pad from the piston, push the piston into the cylinder 3 - 5 mm. Put a lever or steel plate between the piston and disc, being
careful not to damage the contact surface of the disc or the piston end.
2. Install the pad. Restore the brake pedal to the original position and step on it 2 - 3 times.
3. Repeat the above procedure more than 5 times and move the piston outward and inward to assure that the piston seat is properly installed.
4. Before driving a vehicle, step on the brake pedal and release it many times.
5. Perform the road test.