Santa Fe GLS V6-2.7L (2002)
3. Remove the following parts from the caliper support.
1. Pad and wear sensor assembly
2. Pad assembly
3. Clip
4. Outer shim
FRONT BRAKE DISC THICKNESS CHECK
1. Using a caliper, measure nominal disc thickness at eight positions, approximately 45° apart and 10 mm (0.39 inch) from the outer edge of the
disc.
Brake disc thickness
Standard value: 26 mm (1.02 inch)
Limit: 24.4 mm (0.96 inch)
Thickness variation (at least 8 positions)
2. Wherever you measure the thickness value use a micrometer. The pad must be less than 0.005mm in the direction of the circumference and less
than 0.05mm in the direction of radius.
3. If the disc is beyond the limits for thickness or unevenness remove it and install a new one.
FRONT BRAKE DISC RUN-OUT CHECK
1. Remove the caliper support, then raise the caliper assembly upward and suspend with wire.
NOTE: Tighten the nuts in order to mount the disc to the hub.