Santa Fe GLS V6-2.7L (2002)
NOTE: The pads for the right and left wheels should be replaced at the same time.
2. Check for worn or damaged dust boots. If dust or mud had entered the caliper assembly through this seal, the caliper assembly must be replaced or
rebuilt.
INSTALLATION
1. Before replacing the brake pads, drain brake fluid from the master cylinder reservoir until it is half full.
2. Install two caliper guide rods and tighten to the specified torque.
Specified torque 22 - 32 Nm (220 - 320 kg-cm, 16.3 - 23.7 ft. lbs.)
3. After filling the master cylinder reservoir with the fluid, bleed the brake line.
Recommended brake fluid : DOT 3, DOT 4