Santa Fe GLS V6-2.7L (2002)
Brake Master Cylinder: Service and Repair
Removal and Installation
REMOVAL
1. Detach the brake tubes from the master cylinder, and then install the plug.
CAUTION: Do not allow brake fluid to remain on a painted surface. Wash it off immediately.
2. Remove the master cylinder mounting nuts and then remove the master cylinder.
INSTALLATION
1. Install the master cylinder to the brake booster.
2. Install the booster and master cylinder to the dash panel.
3. Connect the brake tubes to the master cylinder.
4. Install the vacuum hose tightly.
5. Connect the operating rod to the brake pedal.
6. After filling the brake reservoir with the brake fluid, bleed the system.
CAUTION: Don't disassemble the brake booster.