Santa Fe GLS V6-2.7L (2002)
3.
Lift up the vehicle. Remove the front skid plate (12 mm socket).
4.
Inspect the CKP Sensor.
IF: The wiring of the CKP sensor comes out straight from the top of the sensor (as shown in the picture) AND DOES NOT have a 90 degree
plastic "knob" at the top of the sensor, then REPLACE the sensor, following the instructions below.
IF: The wiring of the CKP sensor comes out at a 90 degree angle from the top of the sensor (as shown in the picture), do not replace the sensor.
Reinstall the front skid plate and the campaign is completed.