Santa Fe GLS V6-2.7L (2002)
OPTION 2:
If the "OLD" ECM ID is S1N7TS0 A, S1N7TS0 B or S1N7TS0 C,
THEN complete the reprogramming procedure AND replace both front 02 sensors
(following the instructions on pages 11 - 13 of this TSB).
Use the Op Code 10B053R0 in claiming this repair (as shown in this TSB). Submit the claim using the Campaign Claim Screen.
NOTE
^
The current ECM ID Will be replaced by the new ECM ID.
^
The program will take approximately 7 minutes to download completely.
If the Hi-Scan Pro does not download the program, use the Manual Update Procedure following this section.
^
Be sure to check and record the current (old) ECM ID to determine if both front oxygen sensors need to be replaced. If the current ECM ID is
one of those listed below, be sure to replace the front oxygen sensors after reprogramming.
^
S1N7TS0A
^
S1N7TS0B
^
S1N7TS0C
WARNING
^
Do not interrupt the reprogramming at any time. The ECM will be rendered inoperative if the program does not download completely.
STEP 10:
The Hi-Scan Pro reinitializes the ECM.
STEP 11:
When the "COMPLETED" message is displayed, check the new ECM ID displayed on the Hi-Scan Pro screen to verify that the correct ECM software
has been downloaded. The ID number should read "S2N7TS0C". Turn the Hi-Scan Pro OFF and the process is complete.
STEP 12: