Santa Fe GLS V6-2.7L (2002)
^
Plug the transaxle case opening with an oil seal cap in order to avoid contamination.
^
Support the driveshaft properly.
^
While loosening the driveshaft nut, do not let the vehicle weight bear on the wheel bearing.
INSPECTION
1. Check the driveshaft boots for damage and deterioration.
2. Check the splines for wear and damage.
3. Check the ball joints for wear and operating condition.
INSTALLATION
1. Installation is the reverse of removal.
NOTE:
1. Tighten the components to the specified torque as shown.
2. Install the washer under the driveshaft nut with the convex side outward, as shown in the illustration, and tighten the nut.
3. Check the quantity of oil in the differential carrier and fill if it is insufficient.