Santa Fe GLS V6-2.7L (2002)
Total: 145 ± 6 gr.
In the joint 100 ± 3 gr.
In the boot 45 ± 3 gr.
5. Tighten the T.J. boot bands.
6. Add the specified grease to the B.J. as much as was wiped out during inspection.
7. Install the boots.
8. Tighten the B.J. boot bands.
9. To control the air in the T.J. boot, maintain the specified distance between the boot bands when they are tightened.
Standard value (A) mm (inch)
LH
M/T: 530 ± 2 (20.9 ± 0.08)
A/T: 516 ± 2 (20.64 ± 0.08)
RH
M/T: 820 ± 2 (32.3 ± 0.08)
A/T: 836 ± 2 (32.91 ± 0.08)
Rear Driveshaft (DOJ-BJ Type)
REAR DRIVESHAFT (DOJ-BJ TYPE)
DISASSEMBLY
CAUTION:
^
Do not disassemble the B.J. assembly.
^
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
^
The boot band should be replaced with a new one.
1. Remove the D.O.J. boot bands and pull the D.O.J. boot from the D.O.J. outer race.
CAUTION: Be careful not to damage the boot.
2. Remove the circlip with a flat-blade screwdriver.
3. Pull out the driveshaft from the D.O.J. outer race.