hyundai Workshop Repair Guides

Hyundai Workshop Service and Repair Manuals

Engine - Stalls On Initial cold Start|Page 1384 > < Engine - Stalls On Initial cold Start|Page 1382
Page 5
background image

8.

Re-install the cowl side lower trim, door scuff trim, and lower crash pad under cover (if applicable).

NOTE:

When installing the cowl side lower trim, center the adapter on the top edge of the cowl side lower trim.

9.

Re-connect the battery ground cable. Start engine and check for proper operation.

WARRANTY INFORMATION

Technical Service Bulletin # 9436005

Date: 941001

Engine - Stalls On Initial cold Start

Group: ENGINE ELECTRICAL

Number: 94-36-005

Date: OCTOBER, 1994

Model: 1989-1991 SONATA (2.4L)

Subject:
INITIAL START STALLING - FIELD FIX KIT

This TSB updates TSB 93-36-001 and provides additional diagnosis procedures.

1989-1991 model year Sonatas with 2.4 L engines and automatic transaxle may stall when the ambient air temperature is 50-70° F and the transaxle is
shifted into gear immediately after starting a cold engine. A Field Fix kit has been designed to correct this condition. This kit does not affect engine
performance at any other time. If a customer has an initial start related complaint, the following steps should be taken:

1.

Verify correct ATF fluid level (ATM vehicles only).

2.

Check for fault codes using the Multi-use Tester.

3.

Verify that basic ignition timing is set to specification (refer to Sonata shop manual).

4.

Verify that the basic idle speed adjustment is set properly (refer to Sonata shop manual).

5.

Verify that the Throttle Position Sensor adjustment is correct (refer to Sonata shop manual).

6.

Verify fuel pressure is correct.

NOTES:
1.

If the above steps do not indicate an out of specification condition, the field fix kit should be installed.

2.

A repair kit contains a modulator, extension harness, adapter and a strap.

PARTS INFORMATION

Engine - Stalls On Initial cold Start|Page 1384 > < Engine - Stalls On Initial cold Start|Page 1382