Sonata V6-2.7L (2004)
![background image](/hyundai/sonata/v6-2.7l/Page-1389002.png)
Circuits which include any solid-state devices should be tested only with a 10-mega Ohm or higher impedance digital multimeter. When measuring
resistance with a digital multimeter, the battery negative terminal should be disconnected. Otherwise, there may be incorrect readings. Diodes and
solid-state devices in a circuit can make an ohmmeter give a false reading. To find out if a component is affecting a measurement, take one reading,
reverse the leads and take a second reading. If different the solid-state device is affecting the measurement.
JUMPER WIRE WITH FUSE
Use a jumper wire with a fuse to by-pass an open circuit.
A jumper wire is made up of an in-line fuse holder connected to a set of test leads. This tool is available with small clamp connectors providing adoption
to most connectors without damage.
CAUTION: Do not use a fuse with a higher rating than the specified fuse that protects the circuit being tested. Do not use this tool in any situation to
substitute an input or output at the solid-state control module, such as ECM, TCM, etc.
SHORT FINDER
A short tinder is available to locate a short to ground. The short tinder creates a pulsing magnetic field in the shorted circuit and shows you the location
of the short through body trim or sheet metal.
TROUBLESHOOTING TEST