Sonata V6-2.7L (2004)
NOTE: When discarding the gas pressurized shock absorber, follow the disposal procedure.
DISPOSAL
1. Fully extend the shock absorber rod.
2. Drill a hole on the A section to remove gas from the cylinder.
CAUTION: The gas coming out is harmless, but be careful of chips that may fly up when drilling. Be sure to wear face shield and safety goggles.
REASSEMBLY
1. Install the special tools (J38402, A-20), spring compressor, on the coil spring and compress the spring.
After spring is fully compressed, install it on the shock absorber assembly.
NOTE:
1. Do not use an impact gun.
2. Coil spring installation chart to load classification.
2. Install the dust cover, upper spring pad, bushing (B), bracket, bushing (A) in that order and hand tighten the new self-locking nut.
