Sonata GL V6-2.5L (1999)
9.
Insert the retaining clip on the plastic wiring tie-clamp into the air intake hose clamp hole. Install the MAF sensor connector, making sure to
reinstall the metal locking clip that was removed in Step 3.
10.
Reconnect the battery cable.
11.
Check the engine for proper operation after starting.
12.
Set the radio station buttons to the customer's pre-set stations and reset the clock.
ECM Reprogramming
NOTE:
Before conducting the ECM reprogramming, apply lubricant to the MAF sensor female connector terminals as described in step 7 in the "Air Intake
Hose Clamp Replacement" procedure.
CAUTION:
Before Conducting Reprogramming
^
Conduct reprogramming with the ignition key in the "ON" position
^
The DLC (Data Link Connector) cable should never be disconnected from either the vehicle or the Hi-Scan during reprogramming.
WARNING:
If reprogramming is interrupted, the manual update procedure must be used.
^
Do not start the engine during reprogramming.
^
Do not turn the ignition key off during reprogramming.
Downloading Reprogramming Software
1.
Reprogramming software pack 09-15-00 is required for this campaign.
2.
If you do not already have this software, log on to the Service Technology Web Site (www.hmaservice.com) and click on "Hi Scan Software
Updates."
NOTE:
This software can be downloaded to your HDS or to a PC.