Sonata GL V6-25L (1999) Automatic Transmission Shifter A/T Specs
-
Check the detent place for wear.
-
Check the bushing for wear or damage.
-
Check the spring for damage or deterioration.
-
Check the pin at the end of the rod assembly for wear.
1. Install set procedure for lock cam.
(1) Move A/T lever to "P" position to set key lockcam and P-locks shown figure 2.
1) Check that key lock cam is located at "B" by detent pin.
2) Move P-lock cam to direction "A" and hold it with hand.
3) Turn set lever to direction "C" to move upward.
4) Fix locking pin portion of P-lock cam at notch of set lever.
2. Adjusting procedure for "P" shift lock and key lock cable.
(1) Check that each lock cam is shown in figure 2.
(2) Install shift lock cable and key lock cable in position. In this case, key lock cable must be fixed to key cylinder and shift lock cable must be
fixed to brake pedal in position.
(3) Temporarily install each cable to A/T lever assemblies show in figure 3. Securely insert cable end into fixing pin of each cam.
(4) Press set lever lightly to direction "D" and fix P-lock cam securely.
(5) Doing the work of (4). Slightly pull outer casing of shift lock cable to direction "E" to stretch cable in this case. P-lock cam must not move.
(6) After checking portion of cable end touches cable fixing pin of P-lock cam. Fix outer casing with nut.
(7) Again check that cable end touches and fix inner casing with washer and snap pin.
(8) Slightly push key lock cam to direction "O".
(9) Doing the work of (8), slightly pull outer casing of key lock cable direction "G" to stretch cable. Then fix outer casing with nut.