Sonata GLS V6-2.5L (2000)
1. Install the pad clips.
2. Install the pads onto each pad clip.
NOTE:
1. All four pads must be replaced as a complete set.
2. Position the pad with its pad wear sensor upward on piston side.
3. Remove rust before position the pad clip or replace new one if it is damaged.
3. Press in piston with a hammer handle or equivalent.
4. Lower and insert the brake cylinder carefully so as not to damage the boot.
5. Install the two guide rod bolts and tighten.
Guide rod bolt: 22 - 32 Nm (220 - 320 kg.cm, 16 - 24 ft. lbs.)