Sonata GLS V6-2.5L (2000)
2. Install tensioner arm and plane washer to cylinder block.
3. Install tensioner pulley to the tensioner arm.
4. Install sprockets and align the timing mark.
NOTE:
-
When installing camshaft sprocket, fasten the sprocket tightly with holding the hexagonal part of the camshaft.
-
Before installing timing belt, if the timing marks of cam sprocket and cylinder head cover do not coincide, do not rotate the cam sprocket more
than 3 teeth of sprocket in any direction.
Rotating sprocket more than 3 teeth might make valve and piston touched each other.
-
In case of rotating the cam sprocket unavoidably more than 3 teeth, rotate the cam sprocket after rotating 3 teeth in the side of crank
counter-clockwise on the base of timing mark.
5. Install the auto tensioner to the front case.
NOTE: At this time auto tensioner's set pin should be assembled completely.
6. Align the timing marks of each sprocket and install the timing belt in this order.
Crankshaft sprocket -> Idler pulley -> intake cam sprocket (LH side) -> Power steering pump pulley -> Intake cam sprocket (RH side) ->
Tensioner pulley.
NOTE:
In this step, No. 1 is in TDC (Compression stroke)
Do not insert fingers.
7. Pull out the set pin of the auto tensioner.
