Sonata GLS V6-2.5L (2000)
The middle hole is 7/8" from the flange edge, 1/4" forward of the depression, as shown in the photo.
7.
Use a 9/32" (7 mm) drill bit and a drill stop to drill the holes in the seat frame.
NOTE
A drill stop is required. Fuel hose or vacuum hose can be used. Do not allow the drill to penetrate the seat frame by more than 1".
NOTE
Vacuum the loose metal chips.
8.
Insert wire ties (2) into the middle and rear holes.
9.
Position the connector about midway between the front and middle holes and secure the SAB wire in the middle and rear wire ties. Trim the extra
wire tie lengths.