Sonata GLS V6-2.5L (2000)
22. With the rack placed at the center position, attach the rack support plug to the gear housing. Tighten the rack support plug within the range of 20 -
25 Nm (200 - 250 kg-cm, 14.5 - 18 ft. lbs.), using the special tool. Loosen the rack support plug for approximately 10° and adjust torque to the
standard value.
Total pinion torque [Standard value]: 0.6 - 1.3 Nm (6 - 13 kg-cm, 0.4 - 0.9 ft. lbs.)
23. After adjusting, lock rack support plug with lock nut.
NOTE: When it cannot be adjusted within the specified return angle, check rack support plug components or replace.
24. Tighten the feed tube to the specified torque and install the mount rubber using adhesive.
25. Apply the specified grease to the bellows fitting position (fitting groove) of the tie rod.
Recommended grease: Multipurpose grease SAE J310a, NLGI grade #2 EP
26. Install the new attaching band to the bellows.
CAUTION: Whenever the bellows are installed, a new band must be used.
27. Install the bellows in, taking care not to twist it.
28. Fill the dust cover inner side and lip with the specified multipurpose grease, and fix the dust cover in position with the clip ring attached in the
groove of the tie rod end.
Recommended grease: Multipurpose grease SAE J310a, NLGI grade #2 EP
29. Install the tie rods so that the length of the left and right tie rods will be equal to the standard value.
Tie rod free length [Standard value]: 47.2 mm (1.86 inch)
