Sonata GLS V6-2.7L (2002)
20. Install the tab washer and then the tie rod and peen the tab washer end at two points to the tie rod.
CAUTION:
1. Align the tab washer pawls with the rack grooves.
2. Use a new tab washer.
21. Install the bushing, rack support, rack support spring and rack support cover in the order shown. Apply thread sealant to the threaded section of the
rack support cover before installation.
22. With the rack placed at the center position, attach the rack support plug to the gear housing. Tighten the rack support plug within the range of 20 -
25 Nm (200 - 250 kg-cm, 14.5 - 18 ft. lbs.), using the special tool. Loosen the rack support plug for approximately 10° and adjust torque to the
standard value.
Standard value
Total pinion torque 0.6 - 1.3 Nm (6 - 13 kg-cm, 0.4 - 0.9 ft. lbs.)
23. After adjusting, lock rack support plug with lock nut.
NOTE: When it cannot be adjusted within the specified return angle, check rack support plug components or replace.
24. Tighten the feed tube to the specified torque and in stall the mount rubber using adhesive.
25. Apply the specified grease to the bellows fitting position (fitting groove) of the tie rod.
Recommended grease: Multipurpose grease SAE J310a, NLGI grade #2 EP
26. Install the new attaching band to the bellows.
CAUTION: Whenever the bellows are installed, a new band must be used
27. Install the bellows in, taking care not to twist it.
