Sonata GLS V6-2.7L (2002)
2. Before installing the boots, place a new clamps to the small boot ends and install them to the driveshaft.
3. After aligning the matchmark, place the beveled side of the tripod axial spline toward the A.C. joint.
4. Using suitable tool and hammer, tap in the tripod to the driveshaft.
5. Install new snap ring.
6. Add specified grease to the A.C. joint and boot, as much as was removed at the time of inspection.
Specified grease: CENTURY
Grease quantity (gr.)
In the boot: 70 ± 5
In the joint: 115 ± 5
7. Apply specified grease to the G. I. joint and boot.
Specified grease: One luber GKN
Grease quantity (gr.)
In the boot 60 ± 5
In the joint 100 ± 5
8. Align the matchmarks and install the G.I. joint to the shaft.
9. Install the boots.
NOTE: Make sure that 2 boots are on the shaft groove. Make sure that the 2 boots are not stretched.
10. Position the holes in the clamp's free end to the closing hooks.
