Tiburon L4-1.8L (1997)
Drive Belt: Adjustments
A/C
NOTE:
-
The belt deflection must be measured between the specified pulleys.
-
When a new belt is installed, adjust the deflection to the center of the standard range indicated under "New." Let the engine idle for 5 minutes or
more, and check the standard value indicated under "inspection."
-
When adjusting a used belt or a newly installed belt after 5 minutes or more of operation, refer to the standard value indicated under "Used."
-
Refer to the standard value indicated under "Inspection" for periodic inspections.
CAUTION: If the belt is too loose, there will be noise or premature wear.
1. Loosen the tension pulley adjustment bolt A.
2. Adjust the belt deflection with adjustment bolt B.
3. Tighten the fixing bolt A.
4. Re-check the belt deflection as follows:
-
Turn engine at least one full revolution.
-
Apply 100 N (22 lbs.) pressure midway between pulleys to measure deflection.
Deflection Specification
Inspection
8.0 mm (0.315 inch)
New Belt
5.0-5.5 mm (0.197-0.217 inch)
Used Belt
6.0-7.0 mm (0.236-0.276 inch)