Tiburon L4-1.8L (1997)
2. Remove the inner ring, spacer, 4th gear, needle roller bearing, bearing sleeve, synchronizer rings, 3rd and 4th gear synchronizer hub and sleeve
and 3rd gear all together using the special tool (09432 - 33200) or equivalent.
INSPECTION
Input Shaft
1. Check the outer surface of the input shaft where the needle roller bearing is mounted for damage or abnormal wear [portion (A)].
2. Check the splines for damage or wear.
Needle Roller Bearing
1. Install the needle roller bearing on the shaft with the bearing sleeve and gear. Check that it rotates smoothly without abnormal noise or play.
2. Check the needle roller bearing cage for distortion.
Synchronizer Ring
1. Check the clutch gear teeth for damage.
2. Check the internal surface for damage, wear or broken grooves.