Tiburon L4-2.0L (1999)
Tie Rod End: Testing and Inspection
CHECKING TIE ROD END BALL JOINT STARTING TORQUE
1. Mount two nuts on the ball joint, and then measure the starting torque.
Standard Value:
Tightening torque:
Tie rod end ball joint starting torque: 0.5 - 2.5 Nm (5 - 25 kg.cm, 4 - 22 ft. lbs.)
2. If the starting torque exceeds the upper limit of standard value, replace the tie rod end.
NOTE: Even if the starting torque is below the lower limit of the standard value, the ball joint may be reused unless it has drag and excessive
play.