Cruise Control Switch: Testing and Inspection
- Make
- Hyundai
- Model
- Tiburon
- Engine
- V6-2.7L
- Year
- 2004
- Section
- Cruise Control Switch › Testing and Inspection
Cruise ControlTesting and Inspection · page 1 of 2
Cruise Control Switch: Testing and Inspection
CRUISE CONTROL SWITCH TEST
1. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes
2. Remove the driver's airbag.
3. Disconnect the control switch connector.
4. Check the continuity between the terminals of the connector in each switch position according to the table. If there is continuity, and it matches the
table, the switch is O.K. If there is no continuity, replace the control switch.
Pinch or Ctrl + scroll to zoom. Double-tap to reset.
Parts & tools for this job For 2004 Hyundai Tiburon 2.7L
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.