Tucson AWD L4-2.0L (2007)
2. Choose the correct clamping slot for the wire and strip of the wire coat.
-
If the incorrect crimping slot is used the terminal may be damaged and may not fit into the connector.
2. Use of Remover tool set (TRK002)
Flat tip type: Removal of single locking male/female terminal from the connector.
1. Remove the front or rear retainer (holder, stopper) of the connector.
2. Ensure that the tip of the tool is inserted into the gap between the elastic arm of key and terminal.
3. Remove the terminal and check the terminal condition, if there is a damaged, replace it with a new terminal.
Double tip type: Removal of double locking male/female terminal from the connector.
3. Use of terminal tension gauge set (TRK003)
1. Select the tension gauge that matches the female terminal to be checked.