Tucson AWD L4-2.0L (2007)
7. Push the axle hub (B) outward and separate the drive shaft (C) from the axle hub (B).
8. Insert a pry bar (A) between the differential case (B) and joint case (C), and separate the driveshaft (D) from the differential case.
CAUTION:
^
Use a pry bar (A) being careful not to damage the transaxle and joint.
^
Do not insert the pry bar (A) too deep, as this may cause damage to the oil seal (max. depth: 7 mm (0.28 inch).
^
Do not pull the driveshaft by excessive force or it may cause components Inside the BJ or DOJ joint kit to dislodge resulting in a torn boot or a
damaged bearing.
^
Plug the hole of the transaxle case with the oil seat cap to prevent contamination.
^
Support the driveshaft properly.
^
Replace the retainer ring whenever the drive shaft is removed from the transaxle case.
Inspection
REAR DRIVESHAFT (DOJ-BJ TYPE)