Tucson AWD L4-2.4L (2010)
Rear Door Panel: Service and Repair
Door Trim Replacement
Replacement
Door Trim Replacement
NOTE:
-
When prying with a flat-tipped screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
-
Put on gloves to protect your hands.
1. Using a screwdriver or remover, remove the delta inner cover (A).
2. After loosening the mounting screw, then remove the door inside handle housing (B).
3. Loosen the mounting screws, then remove the door trim (A).
4. Push the lock pin (A), disconnect the power window connector (B).
5. Installation is the reverse of removal.
NOTE:
-
Make sure connectors are connected properly and each rod is connected securely.
-
Make sure the door locks/unlocks and opens/closes properly.
-
Replace ant damaged clips.