Tucson AWD L4-2.4L (2010)
Rear Door Window Motor: Service and Repair
Door Module Assembly Replacement
Replacement
Door Module Assembly Replacement
1. Remove the following parts.
A. Door trim
B. Door screen
C. Window glass
D. Outside handle
2. Loosen the mounting screw (A).
3. After loosening the mounting nuts, then remove the rear channel (A).
Tightening torque :
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)
4. Loosen the door module mounting bolts and latch mounting screws.
5. Remove the door module (A).
Tightening torque :
6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.0 lb-ft)
6. Disconnect the connector (A) and power window motor connector (B)
7. Remove the wiring mounting clip.