Tucson AWD L4-2.4L (2010)
Brake Pedal Assy: Service and Repair
Repair Procedures
Removal
1. Remove the crash pad lower panel. .
2. Pull down steering column shaft after removing bolts and nuts.
3. Disconnect the stop lamp switch connector (A).
4. Remove the brake pedal member mounting nut (A).
Tightening torque:
16.5 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)
5. Remove the snap pin (A) and clevis pin (B).
6. Remove the brake pedal member assembly mounting nuts and then remove the brake pedal assembly.
Tightening torque:
16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb-ft)
Installation
1. Installation is the reverse of removal.
CAUTION: