Tucson AWD L4-2.4L (2010)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the engine coolant temperature sensor connector (A).
3. Remove the fixing clip (A), and then pull the sensor from the water temperature control assembly.
CAUTION:
Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.
4. Supplement the engine coolant .
Installation
CAUTION:
-
Install the component with the specified torques.
-
Note that internal damage may occur when the component is dropped.
CAUTION:
-
Apply the engine coolant to the O-ring.
CAUTION:
-
Insert the sensor in the installation hole and be careful not to damage.
1. Installation is reverse of removal.