Tucson AWD L4-2.4L (2010)
14. Connect the PCV hose (A) and exhaust OCV connector (B).
15. Install the ignition coils and then connect the ignition coil connectors (C).
16. Install the crankshaft pulley (B).
Tightening torque :
166.6 - 176.4N.m (17.0 - 18.0kgf.m, 122.9 - 130.1lb-ft)
NOTE:
Use the SST (Ring gear stopper, 09231-2B100) to install the crankshaft pulley bolt, after remove the starter.
17. Install the water pump pulley (A).
Tightening torque :
7.8 - 9.8N.m (0.8 - 1.0kgf.m, 5.8 - 7.2lb-ft)
18. Install the drive belt tensioner pulley (B).
Tightening torque :
53.9 - 63.7N.m (5.5 - 6.5kgf.m, 39.7 - 47.0lb-ft)
NOTE:
The tensioner pulley bolt has LEFT handed threads.
19. Install the idler (A).
Tightening torque :
53.9 - 63.7N.m (5.5 - 6.5kgf.m, 39.7 - 47.0lb-ft)