Tucson AWD L4-2.4L (2010)
Variable Induction Control Actuator: Service and Repair
Variable Intake Solenoid (VIS) Valve
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2. Disconnect the variable intake solenoid valve connector (A).
3. Disconnect the vacuum hoses (B) from the valve.
4. Remove the installation nut (C), and then remove the valve from the surge tank.
Installation
CAUTION:
-
Install the component with the specified torques.
-
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
CAUTION:
-
Be careful of foreign material not to flow into the valve.
1. Installation is reverse of removal.