Tucson AWD L4-2.4L (2010)
Air Bag: Service and Repair
Passenger Airbag (PAB) Module
Components and Components Location
Components
Repair Procedures
Removal
1. Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2. Remove the glove box housing. .
3. Disconnect the passenger airbag connector and remove the PAB mounting bolt.
4. Remove the crash pad. .
NOTE:
Replace the crash pad which is damaged while PAB is deployed.
5. Remove the heater duct from the crash pad.
6. Remove the mounting nuts(4EA) from the crash pad. Then remove the passenger airbag.
CAUTION:
The removed airbag module should be stored in a clean, dry place with the airbag cushion up.
Installation
1. Remove the ignition key from the vehicle.
2. Disconnect the battery negative cable from battery and wait for at least three minutes before beginning work.
3. Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.
Tightening torque
: 5.9 - 6.9 Nm (0.6 - 0.7 kgf.m, 4.3 - 5.1 lb.ft)