Tucson AWD L4-2.4L (2010)
Seat Belt Height Adjuster: Service and Repair
Height Adjust Relacement
1. Remove the following items first :
A. Front door scuff trim
B. Rear door scuff trim
C. Front seat belt lower anchor
D. Front seat belt upper anchor
E. Center lower pillar trim
F. Center upper pillar trim
2. After loosening the mounting bolt, then remove the height adjustor (A).
Tightening torque :
39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)
3. Installation is the reverse of removal.
NOTE:
-
Replace ant damaged clips.
-
Make sure the height adjust properly.