Tucson AWD L4-2.4L (2010)
Ignition Switch: Service and Repair
Removal
1. Disconnect the negative (-) battery terminal.
2. Remove the steering column upper and lower shrouds.
3. Remove the ignition switch (A) after disconnecting the 6P connector (B).
4. Remove the key warning and immobilizer connector (A).
5. Remove the key illumination lens (A).
6. If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder after pushing lock pin (B) with key ACC.
Installation
1. Install the key lock cylinder.
2. Install the illumination bulb, lens and cover.
3. Install the key warning and immobilizer connector.
4. Install the ignition switch.
5. Install the steering column shrouds and crash pad lower panel.