Tucson AWD L4-2.4L (2010)
Reassembly
1. Wrap tape around the driveshaft splines (VTJ. side) to prevent damage to the boots.
2. Apply grease to the driveshaft and install the BJ boots.
3. Install the bands to both BJ boots.
4. To reassemble the dynamic damper (A), keeping the shaft (B) in the straight, tighten the dynamic damper (A) with dynamic damper band (C), as
the illustration.
5. Install the VTJ boot bands and VTJ boot.
6. Install the spider assembly (A) and the circlip (E) to the spline (C) on the driveshaft.
At this time align the marks (D) each other.
7. Install the clip to the VTJ case (B).
8. Add the specified grease to the VTJ as mush as wiped away at inspection.
9. Install the VTJ boots.
10. Install the bands to both VTJ boots.