Tucson AWD L4-2.4L (2010)
8. Use suction cups (A) to hold the windshield over the opening, align it with the alignment marks (B) made in step 15, and set it down on the
adhesive. Lightly push on the windshield until its edges are fully seated on the adhesive all the way around. Do not open or close the doors until
the adhesive is dry.
9. Scrape or wipe the excess adhesive off with a putty knife or towel. To remove adhesive from a painted surface or the windshield, wipe with a soft
shop towel dampened with alcohol.
10. Let the adhesive dry for at least one hour, then spray water over the windshield and check for leaks. If a leak occurs, let it dry, then seal with
sealant :
A. Let the vehicle stand for at least four hours after windshield installation. If the vehicle must be driven within 4 hours, it must be driven slowly.
B. Keep the windshield dry for the first hour after installation.
11. Reinstall all remaining removed parts. Install the rearview mirror after the adhesive has dried thoroughly. Advise the customer not to do the
following things for two the three days :
A. Slam the door with all the windows rolled up.
B. Twist the body excessively (such as when going I in and out of driveways at an angle or driving over rough, uneven roads)
12. Installation the following items.
A. Front pillar trim
B. Inside rearview mirror
C. Rain sensor
D. Wiper arm
E. Cowl top cover
F. Windshield glass deicer connector
