Tucson AWD L4-2.4L (2010)
CAUTION:
Before remove the wiper motor and linkage assembly, make sure that the linkage is stopped at automatic stop position.
To install the wiper motor crank arm exactly, check that the linkage is aligned with the crank arm in straight line and the angle of each linkages.
Put the match mark on the wiper motor and linkage assembly.
Be careful not to bend the linkage.
8. Remove the lower linkage (A) from the wiper motor crank arm.
CAUTION:
To install the wiper motor crank arm exactly, check that the linkage is aligned with the crank arm in straight line and the angle of each linkages.
Be careful not to bend the linkage.
9. Remove the crank arm (A) after loosening a nut (B).
10. Remove the wiper motor after loosening the 3 screws.
Installation
CAUTION:
Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.
1. Install the wiper motor.
2. Install the crank arm.
Torque :
12.7-17.6Nm (1.3-1.8, kgf.m, 9.4-13.0 lbf.ft)