Tucson AWD V6-2.7L (2009)
2. Install the camshaft sprockets and tighten the bolts to the specified torque.
(1) Temporarily install the camshaft sprocket bolts.
(2) Hold the hexagonal head wrench portion of the camshaft with a wrench, and tighten the camshaft sprocket bolts.
Tightening torque
Camshaft sprocket bolt
90 - 110Nm (9.0 - 11.0kgf.m, 65 - 80lb-ft)
3. Install the idler pulley(B) and the tensioner pulley(A).
Tightening torque
Idler pulley bolt
50 - 60Nm (5.0 - 6.0kgf.m, 36 - 43lb-ft)
Tensioner arm fixed bolt
35 - 55Nm (3.5 - 5.5kgf.m, 25 - 40lb-ft)
NOTE:
Insert and install the idler pulley to the roll pin that is pressed in the water pump boss.
4. Align the timing marks of the camshaft sprocket and crankshaft sprocket with the No.1 piston placed at top dead center and its compression stroke.
5. Set timing belt tensioner.
(1) Using a press, slowly press in the push rod.
(2) Align the holes of the push rod and housing pass a set pin through the holes to keep the setting position of the push rod.
(3) Release the press.
6. Install the timing belt tensioner.
(1) Temporarily install the tensioner with the 2bolts.
(2) Alternately tighten the 2bolts.
Tightening torque
20 - 27Nm (2.0 - 2.7kgf.m, 14 - 20lb-ft)